|
|
|
Concrete Products |
PDF |
| Print | |
E-mail |
|
|
|
CON-KORITE XTRA MORTAR
CON-KORITE develops 3,000 psi compressive strength in one hour and nearly 10,000 psi in 28 days. A long lasting and cost-effective option for severely worn (any thickness greater than 1/4 inch) slats and floors.
Common Uses:
- Slats and pads around feeders and waterers
- Floors in gestation stalls, growing, breeding or holding pens
- Troughs for feeding and watering
- Chipped or broken pieces in slats and curbs
- Alleyway floors
- Re-set penning
- Block and poured wall repari and leveling
CON-KORITE KITS
#KB0100 60 Lb. Kit
(Pail contains 55 lb. bag Mortar, 2-qts. KB25, 1-SETCONTROL) This kit is the best way to get started!
COMPONENTS (Order separately for larger jobs)
#KB0060 55 Lb. Bag CON-KORITE
#KB0061 55 Lb. Pail CON-KORITE
#KB0026 1 Gal. Jug KB25 (4/cs)
#KB0027 5 Gal. Pail KB25
#KB0001 Set Control Pouch
Typical KB25 Use:
1-gallon KB25 per three 55 lb. bags at 1:2 mix with water
1-gallon KB25 per two 55 lb. bags at 1:1 mix with water
1-gallon KB25 per 55 lb. bags using straight resin
Typical Set Control Use: 1-pouch per 55 lbs.
|
|
|
AMOR-ROCK EPOXY OVERLAY – For concrete protection
ARMORCOAT BASE EPOXY is combined with natural silica aggregates to produce an extremely hard tough-wearing uniform textured or smooth (troughs) overlay for new or slightly eroded (less than 1/2 inch) concrete. It is unaffected by the acids produced by animal and feed wastes.
Since 1989 producers have found the ARMOR-ROCK
system to be the most permanent solution for restoring concrete around feeders and waterers and on floors. Wastes flow off the slats removing acids that erode the surface. It’s easy to use too. Just mix, add sand, pour onto the substrate and spread. Add sand to the surface for a textured system or leave smooth (troughs). Use the convenient 6-inch notched squeegee for slat repairs.
Common Uses:
|
Non Slip Overlay
|
Smooth Overlay
|
|
Slats
Floors
Load-out ramps
Feeder pads
|
Troughs |
Typical Coverage:
About 30 sq. ft. per 1.5 gal. unit
Combined with 25 lbs. sand admix and 25 lbs. sand broadcast at 3/16 inch.
|
|
|
An easy to apply single component acrylic sealer. It has excellent resistance to salts, sulfates and other common chemicals in hog facilities. Seal new concrete
or heal weak and stress cracked surfaces. Spray or rollcoat apply.
Clean and Etch
Does a thorough job of removing waste residue and mineral deposits on concrete substrates. It provides a clean, etched surface for maximum bonding.
Typical Coverage: 150 to 200 sq. ft. per gallon mixed 1:2 with water.
|
|
Contact us for information on other VanBerg concrete repair products and their uses, such as Joint Fills and Concrete Conditioner and Etch.
More Info...
|
|
|
